Prinzen PSPC30 - Page 42

OPERATION
Page 42 of 99 USER MANUAL PSPC UM-PSPC-06-E/10-2012
Normal operation to start a new pattern:
- Start on an empty, not running system. No
eggs on roller track, cup conveyor or
vacuum head and a new empty tray on the
output conveyor.
- The light inside the reset pattern button
starts blinking to draw the operator’s
attention to push this button to start the
system with a new pattern.
- Push the reset pattern button.
- Push the start button.
Stopping operation with egg pattern device:
- When the last eggs are entering the infeed
conveyor, switch the clear button to 1.
- When all eggs are removed from the
system and are placed in the tray, switch
the clear button back to 0.
- The light inside the reset pattern button
starts blinking to draw the operator’s
attention to push this button to start the
system with a new pattern.
Filling trays gets out of sequence when:
- The reset pattern button is pushed when
there are still eggs inside the packer.
- The emergency button is pressed while the
roller track and cup conveyor are making a
step forward.
- The system is switched off (or power
failure) while the roller track and cup
conveyor are making a step forward.
When filling trays is out of sequence follow
below procedure:
- Stop the system and remove all eggs out
of the packer (roller track, cup conveyor,
vacuum head).
- Remove the tray on the output conveyor.
- Push the reset pattern button.
- Push the start button.