42/84
2015/02 - Indice de révision : B - Code : 29650
VI. CHLORINE STABILISATION:
The Chlorine introduced into the pool by the
electrolysis cell is unstabilised active Chlorine that
is easily destroyed by UV light and heat.
To limit this phenomenon while the pool is
uncovered, the addition of a Chlorine stabiliser,
recommended.
The Chlorine stabiliser does not break down over
time; if the pool was disinfected with Chlorine
before the electrolyser was installed, measure the
initial stabiliser concentration before adding any
the action of Chlorine and falsify measurement of
VII. STARTING THE ELECTROLYSER:
Once the electrolyser is wired in, hydraulic
connections have been made, the water parameters
have been adjusted and the salt and stabiliser have
been completely dissolved, the device may be
switched on.
1) Upon being energised, the message OFF is
displayed on the LCD screen. Press the ON/OFF
button (7).
adequate (> 5 m3/h), the message ON (EES) or
AUTO (EES Pro - indicating that production of
is displayed at the bottom of the LCD screen: the
device is able to produce Chlorine.
If the message STD-BY (stand-by) is shown, the
timer to the I position.
NO FLOW is displayed. Check
the following:
•
• the pump is properly primed
• the pump is rotating in the correct direction (in the
case of a 3 phase pump)
• The valves on the by-pass loop are correctly
and the 2 valves upstream and downstream of
•
mounted upside down
•
EES control panel
•
ohmmeter check the continuity of the 2 connector
contacts while water is circulating.
ON for EES, AUTO
for EES Pro), the device begins by measuring
water salinity, this value is displayed 1 minute
after the device starts up. After this delay, if the
salt concentration is within acceptable limits,
the production of Chlorine begins and gradually
increases. Upon reaching the required level, the
bar under Output % stops blinking and disappears.
To Next Page
Loading...
Need help?
General
