Promise Technology SMARTSTOR NS4300N Product Manual

SmartStor NS4300N Product Manual
146
Checking Enclosure Status in PASM
To check Enclosure status:
1. Start PASM.
See “PASM in your Browser” on page 86.
Or see “PASM in SmartNAVI” on page 87.
2. In the Tree, click the + beside the System icon.
3. Click the System Information icon.
4. Click the Enclosure Information tab.
See Figure 5.
Migration or Rebuilding
on array X paused at Y%.
RAID Volume Migration or Rebuild was paused
temporarily by user action.
Migration or Rebuilding
on array X resumed at
Y%.
RAID Volume Migration or Rebuild was paused and
then resumed by user action.
Migration or Rebuilding
on array X completed.
RAID Volume Migration or Rebuild has finished.
Normal.
Migration or Rebuilding
on array X aborted at Y%
RAID Volume Migration or Rebuild was aborted
(stopped) by user action.
Migration or Rebuilding
on array X aborted at Y%
because of error.
RAID Volume Migration or Rebuild has aborted
(stopped) because of an error. Check the disk drives.
See page 138. Check the RAID Volume. See
page 139.
RAID status: "OFFLINE".
The NS4300N X volume
Y is offline.
Check the disk drives. See page 138. Replace the
failed drive. See page 139. Create a new RAID
Volume. See page 108.
RAID status: "CRITICAL".
The NS4300N X volume
Y is not functioning
correctly.
Check the disk drives. See page 138. Replace the
failed drive. See page 139. The RAID Volume will
rebuild automatically.
RAID X had some errors.
Formatting was aborted!
Check the disk drives. See page 138. Replace the
failed drive. See page 139.
Reported Event Corrective Action

Promise Technology SMARTSTOR NS4300N Specifications

General

Brand	Promise Technology
Model	SMARTSTOR NS4300N
Category	Storage
Language	English