Chapter 5: SmartNAVI
73
Making Management Settings
This category includes the following topics:
• Configuring a NAS System (page 73)
• Changing Network Settings (page 75)
• Locating the SmartStor (page 76)
• Choosing a Default NAS System (page 76)
• Enabling or Disabling Event Notification (page 76)
• Viewing the System Event Log (page 77)
• Adding Plug-ins (page 77)
• Viewing a List of Plug-ins (page 78)
• Viewing Plug-in Version Numbers (page 78)
• Enabling and Disabling Plug-ins (page 79)
• Removing Plug-ins (page 79)
Configuring a NAS System
The Setup Wizard has two modes:
• One Click Setup – Loads a collection of default settings. Recommended for
most users.
• Advanced Setup – Enables you to make your own settings. Recommended
for advanced users.
One Click Setup
To configure your NAS system using One Click Setup:
1. Go to the Main Window.
2. Click the Setup Wizard icon.
3. Click the One Click Setup button.
4. Click the OK button.
Advanced Setup
To configure your NAS system using Advanced Setup:
1. Go to the Main Window.
2. Click the Setup Wizard icon.
Caution
Do NOT run the Setup Wizard on a NAS system that is already
configured! That action will delete your data and network drives!
To Next Page
Loading...
Need help?
General
