User Manual
PROTEC GmbH & Co. KG, In den Dorfwiesen 14, 71720 Oberstenfeld, Germany
2 Press and hold the replenishment time button (7), switch the unit on
5.2.11.2 Manual cancellation of the auto fill function
3 Press and hold the replenishment time button (7) and press „arrow down“ button (3)
5.2.12 Manual Mode
In the manual mode, the processor works without the film detection switches. The film transport has to
be started and stopped manually. All the set values in the manual mode are also valid in the automatic
mode. Please note that the Infeeding-film display (“– –”) is deactivated. Replenishment continues to
operate based on detection of the film surface processed. Only if the film detection switches are
activated, will film measurement be performed. In the manual mode, a replenishment cycle can also be
activated manually.
5.2.12.1 Switching to manual mode:
Switch the machine on. During stand-by, press the arrow-buttons “up” (2) and “down” (3)
simultaneously. When in manual mode the display is flashing.
5.2.12.2 Switching back to automatic mode:
In manual mode with film transport off press both arrow-buttons “up” (2) and “down” (3)
simultaneously.
5.2.12.3 Manual starting and stopping the film transport
1 Switch to manual mode
2 Press the processing time button (4) – the button illuminates
3 Start the film transport by pressing the arrow-button "up" (2) or stop the film transport by
pressing the arrow-button „down“ (3)
5.2.12.4
Manual replenishment
1 Switch to manual mode
2 Press the replenishment time button (7) – the button illuminates
3
Start the replenishment cycle by pressing the arrow-button „up“ (2) or cancel the
replenishment cycle by pressing the arrow-button „down“ (3)
5.2.13
Water Saving Mode
The water saving mode reduces the water consumption. If the water saving mode is activated, exactly
50 % less water is consumed.
5.2.13.1
Activating the water saving mode
1 Switch the unit off
2 Press and hold the buttons processing time (4) and dryer output (6) simultaneously
3 Switch the unit on again and release the pressed buttons
4 Switch the water saving mode off or on with the arrow buttons (2 and 3). If you enter "0, the
water saving mode is off, if you set „1“ it is on
5
Switch the unit off to save the settings
5.2.13.2
Stop Film Transport
In a case of a film-jam inside interrupted. To stop the film simultaneously. Related topics:
see “Manual starting and stopping the film transport:” 5.2.12.3
see “Film is caught up in the racks”: 5.3.2.10
To Next Page
Loading...
