Pulsar ACCOLADE 2 LRF User Manual

Wi-Fi Settings
This menu option allows you to set up your device for operation in a Wi-Fi network.
1.
Press and hold down the Menu (3) button to enter the main menu.
2.
Select the Wi-Fi Settings
Image not found or type unknown
menu option with the UP (2)/ DOWN (5) buttons.
3.
Press briefly the Menu (3) button to enter submenu.
4.
Select the desired menu item with the UP (2) / DOWN (5) buttons.
Password Setup
This menu option allows you to set a password to access your thermal imager from an
external device.
The password is used to connect an external device (i.e. smartphone) to your thermal imager.
1.
Press briefly the Menu (3) button to enter the Password Setup submenu .
2.
The default password (12345678) will appear on the screen.
3.
Set the desired password with the UP (2) / DOWN (5) buttons.
4.
Switch between digits with a short press of the Menu (3) button.
5.
Save the password and exit the submenu with a long press of the Menu (3) button.
Access Level Setup
This menu option allows you to set required access level of the Stream Vision application to
your device.
Access level Owner.The Stream Vision user has the complete access to all device's
functions.
Access level Guest. The Stream Vision user has the access only to the real time video
stream from the device.
1.
Press briefly the Menu (3) button to enter the Access Level Setup submenu.
2.
Select the access level with the UP (2) / DOWN (5) buttons.
3.
Press and hold the Menu (3) to confirm your selection and exit from the submenu.
To see the button operation scheme click here.

Pulsar ACCOLADE 2 LRF Specifications

General

Objective Lens Diameter	50 mm
Detection Range	1800 m
Sensor Resolution	640x480 pixels
Display Type	AMOLED
Pixel Pitch	17 µm
Frame Rate	50 Hz
Laser Rangefinder Range	1000 m
Protection level	IPX7
Dimensions	164x130x64 mm
Waterproof	Yes
Fogproof	Yes
Weight	0.7 kg
Display Resolution	640x480 pixels
Operating Temperature	-25 … +50 °C
Battery Type	Li-Ion Battery Pack