Built-In Laser Rangefinder
The binoculars are equipped with a built-in rangefinder (17), allowing you to measure distance
to objects up to 1000m away.
How the rangefinder works:
1.
Turn on the device, set up image according to section Powering On and Image Setting,
2.
Press the UP (2) or LRF (21) button on remote control - rangefinding reticle appears; in
the top right corner of the display dashes of distance values with unit of measurement
appear, i.e. the rangefinder enters the stand-by mode.
3.
If PiP mode is activated, the aiming reticle disappears upon activation of the rangefinder
and the PiP window remains active.
4.
Point the rangefinding reticle at an object and press the UP (2) button.
5.
In the top right corner of the display you will see distance in meters (or yards -
depending on settings).
Note: if the rangefinder is idle longer than for 4 seconds, it turns off automatically.
Operation in SCAN mode:
1.
To measure distance in scanning mode, hold down the UP (2) or LRF (21) button on
remote control for longer then two seconds. Measurement readings will be changing in
real time as you point the binoculars at different objects. Message SCAN appears in the
top right corner.
2.
To exit SCAN mode, press UP (2) or LRF (21) button again.
3.
If measurement fails, dashes will appear on the display.
4.
In 4 seconds of inactivity (no measurement is taken) the rangefinder turns off, the
rangefinding reticle with readings disappears from the display.
To Next Page
Loading...
Need help?
General
