Pulsar ACCOLADE 2 LRF User Manual

Wi-Fi Function
Your thermal imager features wireless connection option (Wi-Fi) which links it with external
appliances (smartphone, tablet PC).
Turn on the wireless module in the WI-Fi Activation menu option.
Wi-Fi operation is shown in the status bar as follows:
Connection status Status bar indication
Wi-Fi is off
Wi-Fi activated by the user,
Wi-Fi in the device is being activated
Wi-Fi is on, no connection with device
Wi-Fi is on, device connected
Your device is detected by an external device as "Accolade 2 LRF_XXXX", where XXXX
– is the last four digits of device's serial number.
After entering the password on an external appliance (see Password Setup subsection
of the Wi-Fi Settings section for more information on setting a password) and connection
is established, the icon in the status bar changes to
Image not found or type unknown
.

Pulsar ACCOLADE 2 LRF Specifications

General

Objective Lens Diameter	50 mm
Detection Range	1800 m
Sensor Resolution	640x480 pixels
Display Type	AMOLED
Pixel Pitch	17 µm
Frame Rate	50 Hz
Laser Rangefinder Range	1000 m
Protection level	IPX7
Dimensions	164x130x64 mm
Waterproof	Yes
Fogproof	Yes
Weight	0.7 kg
Display Resolution	640x480 pixels
Operating Temperature	-25 … +50 °C
Battery Type	Li-Ion Battery Pack