Page 19
Maintenance
There are no user serviceable parts inside your blackbox, except the mains
power fuse. If you experience any problems with the equipment, then please
contact Pulsar Process Measurement for advice.
Important Information
Please note that the on-board Lithium battery, mounted to the
processor PCB, is not user serviceable.
To clean the equipment, wipe with a damp cloth. Do not use any solvents on
the enclosure or transducer.
Important Information
The unique DATEM software comes into operation as soon as
power is applied, and is designed to monitor a moving level or
target with the transducer in a fixed position.
If, after any period of use, it should become necessary to move the
transducer, for any reason, from its original operating position,
switch off the blackbox, before proceeding, to prevent any
undesirable updates to the DATEM trace. If after moving the
transducer the reading is not as expected, please refer to Chapter 6
Troubleshooting.
To Next Page
Loading...
