Page 21
Communication Port Configuration
If the PC Handheld Programmer fails to connect to the blackbox unit you
may need to change the communications port that is being used, to do this
‘right click’ on the PC Handheld Programmer keypad and a ‘pop up’ menu
will appear allowing you to select the appropriate communications port.
Handheld Communicator (Optional)
The optional Handheld communicator can be used to programme any number
of blackbox units and works in a similar way to the PC Software. Connect the
Handheld Communicator, with the cable supplied, to the RS232 interface via
the RJ11 connector located on the terminal connector, inside the blackbox
enclosure. Once connected you will briefly see a message, similar to that as
seen when using the PC Software which, after connecting successfully, will
then change to display the current measurement, dependent on mode and
measurement unit's chosen.
To Next Page
Loading...
Need help?
General
