Page 74
P906 Side Clearance
This parameter is used to set the distance by which the DATEM trace will
“stand-off” from around unwanted echoes such as obstructions. Please consult
Pulsar for further information and assistance on changing the value of this
parameter.
System Parameters
Passcode
P921 Enable Code
Enables the passcode (P922), which means the passcode must be entered to
go into program mode. If disabled (set to 0), then no passcode is required,
and ENTER is used to enter program mode. Default = 1 (Enabled)
P922 Passcode
This is the passcode that must be used to enter program mode. The default is
1997, but this can be changed to another value from 0 to 9999.
System Information
The following three parameters do not affect how the unit performs, but details,
contained in them, may be required, by Pulsar, when making technical enquiries.
P926 Software Revision
This parameter will display the current software revision. It is read only, and
cannot be changed. The software revision can also be viewed, while in RUN
mode, by pressing the decimal point key when using any of the display
options.
P927 Hardware Revision
This parameter will show details of the current hardware revision. It is read
only and cannot be changed.
P928 Serial Number
This parameter will display the unit’s serial number . It is read only, and
cannot be changed. The serial number can also be viewed, while in RUN
mode, by pressing the decimal point key when using any of the display
options.
To Next Page
Loading...
Need help?
General
