Page 42
Applications
This section of the manual deals with more difficult applications. And, service
parameters that may need changing under certain process conditions in order to
have the unit work to an acceptable level.
In order to apply these parameters correctly the user should have a good working
knowledge of Pulsar equipment.
Pulsar PC software should always be used to monitor the echo profile and record
the effect that the parameter changes are having.
1. Liquid applications in tanks/vessels where the surface is slow moving or
still and close to the transducer.
2. Liquid applications in wet wells where the empty distance is close to the
end of the range of the transducer and the surface may be turbulent and/or
foamy.
3. Solids applications where the process is fast moving and the control is
required to be nearly instantaneous, i.e. crusher control.
4. Solids applications where the process is much slower moving and the
product surface may have difficult angles of repose, i.e. bulk solids silos.
To Next Page
Loading...
Need help?
General
