Pulsar Zenith 140 - Page 129

PULSAR MEASUREMENT
129
P812 Pump Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when a pump or general control
relay is switched on or off. The message is in the form “General 1 ON”, where
the number displayed is the number of the relay.
OPTION
DESCRIPTION
0 = No (Default)
Pump messages will not be displayed
1= Yes
Pump messages will be displayed
P813 Control Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when a control relay is switched
on or off. The message is in the form “Time ON”.
OPTION
DESCRIPTION
0 = No (Default)
Control messages will not be displayed
1= Yes
Control messages will be displayed
P814 Miscellaneous Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when a miscellaneous relay is
switched on or off. The message is in the form “Clock ON”.
OPTION
DESCRIPTION
0 = No (Default)
Miscellaneous messages will not be displayed
1= Yes
Miscellaneous messages will be displayed
P815 Auxiliary Source
When P100 = 4 (Average) or 5 (Differential) the auxiliary display line can
be used to display the level on any of the two points of measurement.
OPTION
DESCRIPTION
0 = Off (Default)
Auxiliary display not used to display
measurement readings.
1 = Auxiliary
Displays level from optional Aux input.
2 = Xducer 1
Displays level from transducer 1