Pulsar Zenith 140 - Device Communication Setup; RS232 Communication Setup; RS485 Communication Setup

ZENITH 140 INSTRUCTION MANUAL
152
P979 End Month
This parameter is used to select the month, in which Daylight-Saving Time
will end.
OPTION
DESCRIPTION
1= January
DST will end during the month of January
2= February
DST will end during the month of February
3=March
DST will end during the month of March
4= April
DST will end during the month of April
5= May
DST will end during the month of May
6= June
DST will end during the month of June
7= July
DST will end during the month of July
8= August
DST will end during the month of August
9= September
DST will end during the month of September
10= October (Default)
DST will end during the month of October
11= November
DST will end during the month of November
12= December
DST will end during the month of December
Device Comm.
RS232 Set Up
P061 Comms Baud
This parameter is used to set the speed (Baud Rate) of the RS232
communications and can be changed to suit the connecting device.
Default = 19200
RS 485 Set Up
Please refer to the RS485 communications manual for availability of
parameters and details of their options. This can be found in the downloads
section of the Pulsar website:
https://pulsarmeasurement.com/downloads/instruction-manuals/