PULSAR MEASUREMENT
15
CHAPTER 2 ZENITH 140 INSTALLATION
Unpacking
Power Supply Requirements
The Zenith 140 can operate from AC supply or from a DC battery. The AC is
either 85-120V 50/60Hz or 170-240V 50/60Hz, depending on the position
of the selector switch. The DC is 18-36V. In all cases the Zenith 140 will
typically consume 6W of power, with a maximum of 10W.
Important Information
All shipping cartons should be opened carefully. When using a box cutter, do not
plunge the blade deeply into the box, as it could potentially cut or scratch
equipment components. Carefully remove equipment from each carton,
checking it against the packing list before discarding any packing material. If
there is any shortage or obvious shipping damage to the equipment, report it
immediately to Pulsar Process Measurement Limited.
To Next Page
Loading...