EasyManuals Logo

Pulsar Zenith 140 User Manual

Pulsar Zenith 140
161 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
PULSAR MEASUREMENT
25
Preparation for Operation
Before switching on, check the following:
The Zenith 140 is mounted correctly and is in a ‘safe’ area.
The power supply is correctly installed.
The voltage selector switch is in the correct position.
The relays are connected correctly.
Maintenance
There are no user serviceable parts inside Zenith, except the mains fuse. If
you experience any problems with the unit, then please contact Pulsar
Measurement for advice.
To clean the equipment, wipe with a damp cloth. Do not use any solvents on
the enclosure.
Important Information
The unique DATEM software comes into operation as soon as power is
applied and is designed to monitor a moving level or target with the
transducer in a fixed position.
If, after any period of use, it should become necessary to move the
transducer, for any reason, from its original operating position, switch off
the Zenith, before proceeding, in order to prevent any undesirable updates
to the DATEM trace. If after moving the transducer the reading is not as
expected, please refer to Chapter 6 Troubleshooting.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pulsar Zenith 140 and is the answer not in the manual?

Pulsar Zenith 140 Specifications

General IconGeneral
BrandPulsar
ModelZenith 140
CategoryPower Supply
LanguageEnglish