PULSAR MEASUREMENT
37
CHAPTER 4 QUICK SETUP GUIDE
This quick set-up guide shows you how to get up and running in a few
minutes in just four easy steps after installing your Zenith 140.
Enter Program Mode
First you need to go from run mode into program mode. Assuming the
passcode is the default 1997, then you should enter the following on the
keypad:
Choose Quick Setup
Now you need to go into the quick setup. You will see on the menu the
words ‘Quick Setup’, which is the first item on the menu system. Try pressing
the two arrow keys to see some more menu options, but return to Quick
Setup, and press
This takes you to the common
applications parameter (P200).
This takes you to the common
applications parameters, and you will see
some options appearing on the display.
Factory Defaults
If you have already setup a common application, then there will be a
number shown other than 0, and you will see messages showing what the
current setup is. If you want to reset this and start again, press 0 (which will
reset all the quick setup parameters), otherwise pressing ENTER will allow
you to edit the parameters that have been set.
To Next Page
Loading...
Need help?
General