Enforcer: Programming Manual
Page: 8
NOTE: The learn process is the same on all wireless contacts,
detectors, and sensors. Once the GREEN LED flashes, the learn process
has been successful. If the RED LED flashes, repeat the process above
as the learn procedure has not been successful.
Wireless Device Control Programming: Learning Bells
1. Press or to scroll to 'WIRELESS DEVICE CONTROL'.
Press .
2. 'Control Inputs' will be displayed. Press .
3. 'Control Bells' will be displayed. Press .
4. 'Learn Devices' will be displayed. Press or press to
access the delete menus (you can either delete individual
devices or delete all).
5. Press [ or ] to select the bell (1 or 2) to learn and press
.
6. Open the wireless Deltabell and press and hold the 'LEARN'
button until all LEDs flash then release.
NOTE: Once the GREEN LED flashes, the learn process has been
successful. If the RED LED flashes, repeat the process above as the
learn procedure has not been successful.
Wireless Device Control Programming: Program Keyfob Buttons
1. Press or to scroll to 'WIRELESS DEVICE CONTROL'.
Press .
2. 'Control Inputs' will be displayed. Press .
3. 'Control Bells' will be displayed. Press .
4. 'Program Keyfob Buttons' will be displayed. Press .
5. Press [ or ] to select the user (1-80) and press .
6. Press [ or ] to select the button to be programmed and
LEARN
>5s
Input 01
Available [01]
Learning...
Input Learnt!
LEARN
>5s
WIRELESS DEVICE
CONTROL?
Control Inputs?
Control Bells?
Learn Devices?
Select Bell
Available [1]
Learning...
Bell Learnt!
WIRELESS DEVICE
CONTROL?
Control Inputs?
Control Bells?
IMPORTANT:
For full learning instructions of
each wireless peripheral, please
refer to the manual provided with
the device.
To Next Page
Loading...
Need help?
General
