56
d. After you enter the information click on the Test button (Green box in Fig 7-13) and wait until you see the OK
message in the bottom left hand corner of the screen.
e. Click the [APPLY] button and then the [EXIT] button at the bottom of the NETWORK screen and your DDNS
setup is complete.
Fig 7-13 myq-see
DDNS Server: Select MYQ-SEE from the drop down menu.
Username: The email address you entered on the myq-see site.
Password: Enter the password you setup on the myq-see site.
Host Domain: Enter the account name you setup on the myq-see site.
7.3 Port Forwarding
To access the DVR from a remote computer you need to forward ports 80 and 6036 from the
router the DVR is attached to, to the IP address of the DVR.
1. Connect your DVR to the Router and power on DVR
2. Configure your DVR and Set up port forwarding on your router
a. Go to www.portforward.com/qsee
To Next Page
Loading...
Need help?
General
