To Next Page

To Previous Page

BMC MAINTENANCE GROUP

4-73

Command: ipmitool raw 0x0a 0x24 0x0 0x0 0x51 0xc0 4 0x57 0x01 0x0 0xf5

Response: 55 00 „» 55 is the last record ID

Step 2: get OEM record, to use the last record ID to check if added successfully (

Please refer to IPMI 2.0 Spec. page 466/644)

Command: ipmitool raw 0x0a 0x23 0x0 0x0 0x55 0x0 0x0 0xff

Response: ff ff 55 00 51 c0 04 57 01 0 f5 „» ff ff means record ID 55 is the last record ID

Step 3: go to Web.UI to check “SDR” to be preserved

Step 4: upgrade firmware

Step 5: after Step 4, go to Step 2 and check if the OEM record is still preserved (if pre-

served then PASS else FAIL)

2. SEL

Step 1: Please use IPMI command to add an event. Ex: ipmitool event 1

Step 2: go to Event Log to check if the event added

Step 3: go to Web.UI to check “SEL” to be preserved

Step 4: upgrade firmware

Step 5: after Step 4, go to Step 2 and check if the event is still preserved (if preserved

then PASS else FAIL)

3. IPMI

Step 1: Please add a new user by Web.

Step 2: check if the user added

Step 3: go to Web.UI to check ¡§IPMI¡¨ to be preserved

Step 4: upgrade firmware

Step 5: after Step 4, go to Step 2 and check if the user is still exist (if preserved then

PASS else FAIL)

4. Network

Step 1: Please change BMC IPv4 address source to be STATIC or DHCP mode by Web.

Step 2: check if the mode changed

Step 3: go to Web.UI to check ¡§Network¡¨ to be preserved

Step 4: upgrade firmware

Step 5: after Step 4, go to Step 2 and check if the mode is still preserved (if preserved

then PASS else FAIL)

5. SNMP (supported from Grantley platform)

Step 1: Please go to add a new user and enable SNMP function.

Step 2: check if the user added and SNMP function enabled

Step 3: go to Web-UI to check “SNMP” to be preserved

QCT QuantaGrid Series User Manual

Questions and Answers: