Qlogic SANbox 5800V Series

7 – Zoning Configuration
Displaying Zoning Database Information
59263-02 A 7-3
A
Enter the Zoning List command to display all zone sets, zones, and zone
members in the active zone set and configured zone sets as shown in the
following example. Merged and edited zone sets are displayed if they exist.
SANbox #> zoning list
Active (enforced) ZoneSet Information
ZoneSet Zone ZoneMember
--------------------------------
wwn
wwn_23bd31
50:06:04:82:bf:d2:18:c2
50:06:04:82:bf:d2:18:d2
10:00:00:00:c9:23:bd:31
wwn_221416
50:06:04:82:bf:d2:18:c2
50:06:04:82:bf:d2:18:d2
10:00:00:00:c9:22:14:16
wwn_2215c3
50:06:04:82:bf:d2:18:c2
50:06:04:82:bf:d2:18:d2
10:00:00:00:c9:22:15:c3
Configured (saved in NVRAM) Zoning Information
ZoneSet Zone ZoneMember
--------------------------------
wwn
wwn_23bd31
50:06:04:82:bf:d2:18:c2
50:06:04:82:bf:d2:18:d2
10:00:00:00:c9:23:bd:31
wwn_221416
50:06:04:82:bf:d2:18:c2
50:06:04:82:bf:d2:18:d2
10:00:00:00:c9:22:14:16
wwn_2215c3
50:06:04:82:bf:d2:18:c2
50:06:04:82:bf:d2:18:d2
10:00:00:00:c9:22:15:16