1 – Introduction
Switch Models and Examples
1-2 59263-02 A
S
Switch Models and Examples
The commands and displays of the command line interface vary depending on the
switch model. All examples in this guide are taken from a SANbox 5802V switch
unless stated otherwise.
Intended Audience
This guide is intended for individuals who are responsible for installing and
servicing Fibre Channel equipment using the command line interface.
Related Materials
The following manuals and materials are referenced in the text and/or provide
additional information.
îš„ SANbox 5800V Series Stackable Fibre Channel Switch Installation Guide,
publication number 59265-02
îš„ SANbox 5800V Series QuickTools Switch Management User Guide,
publication number 59264-02
îš„ SANbox 5800V Series Enterprise Fabric Suite 2007 User Guide, publication
number 59266-01
îš„ QLogic Fibre Channel Switch Event Message Guide, publication number
59060-06
îš„ SANbox Simple Network Management Protocol Reference Guide,
publication number, 59047-09
îš„ CIM Agent Reference Guide, publicaton number 59223-03
îš„ QLogic Switch Interoperability Guide. This PDF document can be
downloaded at http://www.qlogic.com/interoperability/interoperability.aspx.
îš„ Fibre Channel-Arbitrated Loop (FC-AL-2) Rev. 7.0.
îš„ Fibre Channel-10-bit Interface Rev. 2.3.
îš„ Definitions of Managed Objects for the Fabric Element in Fibre Channel
Standard (draft-ietf-ipfc-fabric-element-mib-04.txt).
The Fibre Channel Standards are available from:
Global Engineering Documents, 15 Inverness Way East, Englewood, CO
80112-5776 Phone: (800) 854-7179 or (303) 397-7956
Fax: (303) 397-2740.
To Next Page
Loading...
Need help?
General
