5 – Switch Configuration
Testing a Switch
5-30 59263-02 A
S
Displaying Switch Test Status
You can display the test status while the test is in progress by entering the
Test Status Switch command as shown in the following example:
SANbox (admin) #> test status switch
Test Test Test Loop Test
Level Type Status Count Failures
----- ---- ------ ----- --------
Switch Offline internal NeverRun 33 4
Port Test Test Loop Test
Num Type Status Count Failures
---- ---- ------ ----- --------
0 Offline internal StoppedOnError 12 2
1 Offline internal NeverRun 1 0
2 Offline internal Passed 4 0
3 Offline internal NeverRun 1 0
4 Offline internal NeverRun 1 0
5 Offline internal NeverRun 1 0
6 Offline internal NeverRun 1 0
7 Offline internal NeverRun 12 2
8 Unknown NeverRun 0 0
9 Unknown NeverRun 0 0
10 Unknown NeverRun 0 0
11 Unknown NeverRun 0 0
12 Unknown NeverRun 0 0
13 Unknown NeverRun 0 0
14 Unknown NeverRun 0 0
15 Unknown NeverRun 0 0
16 Unknown NeverRun 0 0
17 Unknown NeverRun 0 0
18 Unknown NeverRun 0 0
19 Unknown NeverRun 0 0
20 Unknown NeverRun 0 0
21 Unknown NeverRun 0 0
22 Unknown NeverRun 0 0
23 Unknown NeverRun 0 0
Canceling a Switch Test
To cancel a switch test that is in progress, enter the Test Cancel Switch command.
To Next Page
Loading...
