14 – Command Reference
Command Listing
59263-02 A 14-215
A
Zoning Clear
Clears all inactive zone sets from the volatile edit copy of the zoning database.
This keyword requires a zoning edit session. This keyword does not affect the
non-volatile zoning database. However, if you enter the Zoning Clear command
followed by the Zoning Save command, the non-volatile zoning database will be
cleared from the switch.
Authority Admin session and a Zoning Edit session.
Syntax zoning clear
Examples The following is an example of the Zoning Clear command:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #> zoning clear
SANbox (admin-zoning) #> zoning save
NOTE:
The preferred method for clearing the zoning database from the switch is the
Reset Zoning command.
To Next Page
Loading...
