14 – Command Reference
Command Listing
59263-02 A 14-37
A
Hardreset
Resets the switch and performs a power-on self test (POST). This reset disrupts
I/O traffic, activates the pending firmware, and clears the alarm log. To save the
alarm log before resetting, refer to the “Set Log” on page 14-101.
Authority Admin session
Syntax hardreset
Notes To reset the switch without a power-on self test, refer to the “Reset” command on
page 14-67.
To reset the switch without disrupting traffic, refer to the “Hotreset” command on
page 14-40.
To Next Page
Loading...
