11 – Event Log Configuration
Clearing the Event Log
59263-02 A 11-5
A
Display the Event Log Configuration
Enter the Show Log Settings command to display all event log configuration
settings as shown in the following example:
SANbox #> show log settings
Current settings for log
------------------------
Started True
FilterComponent NameServer MgmtServer Zoning Switch Port Eport Snmp CLI QFS
FilterLevel Info
DisplayLevel Critical
FilterPort 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23
Restore the Event Log Configuration
Enter the Set Log Restore command in an Admin session to return the event log
configuration to the factory default as shown in the following example:
SANbox (admin) #> set log restore
Clearing the Event Log
Enter the Set Log Clear command in an Admin session to delete all entries in the
event log as shown in the following example:
SANbox (admin) #> set log clear
To Next Page
Loading...
