13 – Simple Network Management Protocol Configuration
Displaying SNMP Information
59263-02 A 13-3
A
Displaying SNMP Information
Enter the Show Setup Snmp command to displays common and trap-specific
SNMP configuration information as shown in the following example. Refer to
Table 14-30 for a description of the SNMP parameters.
SANbox #> show setup snmp
SNMP Information
----------------
SNMPEnabled True
Contact <sysContact undefined>
Location N_107 System Test Lab
Description SANbox 5800V FC Switch
ObjectID 1.3.6.1.4.1.3873.1.9
AuthFailureTrap True
ProxyEnabled True
SNMPv3Enabled False
Trap1Address 10.0.0.254
Trap1Port 162
Trap1Severity warning
Trap1Version 2
Trap1Enabled False
Trap2Address 0.0.0.0
Trap2Port 162
Trap2Severity warning
Trap2Version 2
Trap2Enabled False
Trap3Address 0.0.0.0
Trap3Port 162
Trap3Severity warning
Trap3Version 2
Trap3Enabled False
Trap4Address 0.0.0.0
Trap4Port 162
Trap4Severity warning
Trap4Version 2
Trap4Enabled False
Trap5Address 0.0.0.0
Trap5Port 162
Trap5Severity warning
Trap5Version 2
Trap5Enabled False
To Next Page
Loading...
Need help?
General
