11 – Event Log Configuration
Creating and Downloading a Log File
59263-02 A 11-7
A
Creating and Downloading a Log File
Enter the Set Log Archive command to collect the event log messages in a file on
the switch named logfile. This file can have a maximum of 1200 event messages.
Use FTP to download the file from the switch to your workstation as follows:
1. Log into the switch through Telnet and create an archive of the event log.
Enter the Set Log Archive command in an Admin session to create a file on
the switch named logfile.
SANbox #> admin start
SANbox (admin) #> set log archive
2. Open an FTP session on the switch and log in with the account name
images and password images. Transfer the file logfile in binary mode with
the Get command.
>ftp ip_address
user:images
password: images
ftp>bin
ftp>get logfile
xxxxx bytes sent in xx secs.
ftp>quit
To Next Page
Loading...
