14 – Command Reference
Command Listing
14-46 59263-02 A
S
Ipsec Association
Creates and manages associations in the Security Association database.
Authority Admin session and an Ipsec Edit session
Syntax ipsec association
copy [association_source] [association_destination]
create [association]
delete [association]
edit [association]
list [association]
rename [association_old] [association_new]
Keywords copy [association_source] [association_destination]
Creates a new association named [association_destination] and copies the
configuration into it from the association given by [association_source].
[association_destination] must not begin with DynamicSA_, which is reserved for
dynamic associations. You must enter the Ipsec Save command afterwards to
save your changes.
create [association]
Creates an association with the name given by [association]. An association name
must begin with a letter and be no longer than 32 characters. Valid characters are
0-9, A-Z, a-z, _, $, ^, and -. The Security Association database supports a
maximum of 512 user-defined associations. You must enter the Ipsec Save
command afterwards to save your changes.
Table 14-6. Association Configuration Parameters
Parameter Description
Description Description of the association.
SourceAddress IP address (version 4 or 6) or DNS host name of the
host, switch, or gateway from which data originates.
DestinationAddress IP address (version 4 or 6) or DNS host name of the
host, switch, or gateway receiving data. If you spec-
ified an IP address for the SourceAddress, the Des-
tinationAddress must use the same IP version
format.
To Next Page
Loading...
