Qlogic SANbox 5800V Series

14 – Command Reference
Command Listing
14-52 59263-02 A
S
The following is an example of the Ipsec List Association command:
SANbox #> ipsec list association
Active IPsec Information
h2h-sh-sa
Description: Host-to-host: switch->host
Source: fe80::2c0:ddff:fe03:d4c1
Destination: fe80::250:daff:feb7:9d02
Protocol: esp SPI: 333 (0x14d)
Authentication: hmac-sha1 ********
Encryption: 3des-cbc ********
h2h-hs-sa
Description: Host-to-host: host->switch
Source: fe80::250:daff:feb7:9d02
Destination: fe80::2c0:ddff:fe03:d4c1
Protocol: esp SPI: 444 (0x1bc)
Authentication: hmac-sha1 ********
Encryption: 3des-cbc ********
The following is an example of the Ipsec List Policy command:
SANbox #> ipsec list policy
Active IPsec Information
h2h-hs-sp
Description: Host-to-host: host->switch
Source: fe80::250:daff:feb7:9d02/128
Destination: fe80::2c0:ddff:fe03:d4c1/128
Protocol: any
Direction: in Priority: 0 Action: ipsec
Rule Protocol Mode Level
---- -------- --------- -----
1 esp transport require
h2h-sh-sp
Description: Host-to-host: switch->host
Source: fe80::2c0:ddff:fe03:d4c1/128
Destination: fe80::250:daff:feb7:9d02/128
Protocol: any
Direction: out Priority: 0 Action: ipsec
Rule Protocol Mode Level
---- -------- --------- -----
1 esp transport require