14 – Command Reference
Command Listing
14-68 59263-02 A
S
factory
Resets switch configuration, port configuration, port threshold alarm configuration,
zoning configuration, SNMP configuration, system configuration, security
configuration, RADIUS configuration, switch services configuration, zoning
configuration, and Call Home configuration to the factory default values as
described in Table 14-10 through Table 14-18. The switch configuration is
activated automatically.
ipsec
Resets the IP security database configuration to its default values.
port [port_list]
Reinitializes one or more ports given by [port_list]. [port_list] can be a set of port
numbers and ranges delimited by spaces. For example, [0 2 10-15] specifies ports
0, 2, 10, 11, 12, 13, 14, and 15.
radius
Resets the RADIUS configuration to the default values as described in
Table 14-15.
security
Clears the security database and deactivates the active security set. The security
configuration value, autosave, and fabric binding remain unchanged.
services
Resets the switch services configuration to the default values as described in
Table 14-16.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table 14-14 for SNMP configuration default values.
NOTE:
îš„ Because this keyword changes network parameters, the
workstation could lose communication with the switch and release
the Admin session.
îš„ This keyword does not affect installed license keys.
To Next Page
Loading...
Need help?
General
