14 – Command Reference
Command Listing
14-70 59263-02 A
S
Notes The following tables specify the various factory default settings:
îš„ Table 14-9 shows the Call Home service configuration defaults. Enter the
Show Setup Callhome command to display the Call Home service
configuration values.
îš„ Table 14-10 shows the switch configuration default values. Enter the
Show Config Switch command to display switch configuration values.
îš„ Table 14-11 shows the port configuration default values. Enter the
Show Config Port command to display port configuration values.
îš„ Table 14-12 shows the port threshold alarm configuration defaults. Enter the
Show Config Threshold command to display port threshold alarm
configuration values.
îš„ Table 14-13 shows the zoning configuration defaults. Enter the
Show Config Zoning command to display zoning configuration values.
îš„ Table 14-14 shows the SNMP configuration defaults. Enter the
Show Setup Snmp command to display SNMP configuration values.
îš„ Table 14-15 shows the RADIUS configuration defaults. Enter the
Show Setup Radius command to display RADIUS configuration values.
îš„ Table 14-16 shows the switch services configuration defaults. Enter the
Show Setup Services command to display switch services configuration
values.
îš„ Table 14-17 shows the system configuration defaults. Enter the
Show Setup System command to display system configuration values.
îš„ Table 14-18 shows the security configuration defaults. Enter the
Show Config Security command to display security configuration values.
Table 14-9. Call Home Service Configuration Defaults
Parameters Default
PrimarySMTPServerAddr 0.0.0.0
PrimarySMTPServerPort 25
PrimarySMTPServerEnabled False
SecondarySMTPServerAddr 0.0.0.0
SecondarySMTPServerPort 25
SecondarySMTPServerEnabled False
ContactEmailAddress nobody@localhost.localdomain
PhoneNumber <undefined>
To Next Page
Loading...
Need help?
General
