14 – Command Reference
Command Listing
14-128 59263-02 A
S
The following is an example of the Set Setup System Ipv4 command:
SANbox (admin) #> set setup system ipv4
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
EthIPv4NetworkEnable True
EthIPv4NetworkDiscovery Static
EthIPv4NetworkAddress 10.20.116.133
EthIPv4NetworkMask 255.255.255.0
EthIPv4GatewayAddress 10.20.116.1
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
EthIPv4NetworkEnable (True / False) :
EthIPv4NetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) :
EthIPv4NetworkAddress (dot-notated IP Address) :
EthIPv4NetworkMask (dot-notated IP Address) :
EthIPv4GatewayAddress (dot-notated IPv4 Address) :
Do you want to save and activate this system setup? (y/n): [n]
The following is an example of the Set Setup System Ipv6 command:
SANbox (admin) #> set setup system ipv6
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
EthIPv6NetworkEnable False
EthIPv6Discovery Static
EthIPv6NetworkAddress <undefined>
EthIPv6GatewayAddress <undefined>
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
EthIPv6NetworkEnable (True / False) :
EthIPv6Discovery (1=Static, 2=Dhcpv6, 3=Ndp) :
EthIPv6NetworkAddress (IPv6 Address/Mask Length format) :
EthIPv6GatewayAddress (IPv6 Address) :
Do you want to save and activate this system setup? (y/n): [n]
To Next Page
Loading...
Need help?
General
