6 – Port Configuration
Modifying Port Operating Characteristics
59263-02 A 6-9
A
You can configure all ports based a specified source port using the
Set Config Ports command. The following example configures ports 0–23 based
on port 3.
SANbox #> admin start
SANbox (admin) config edit
SANbox (admin) #> set config ports 3
.
.
.
SANbox (admin-config)#> config save
SANbox (admin)#> config activate
SANbox (admin)#> admin end
The following example temporarily changes the port 1 administrative state to
Down:
SANbox #> admin start
SANbox (admin) #> set port 1 state down
To Next Page
Loading...
