4. Power on your transmitter radio and put it into bind mode. Make sure that The D16
protocol is selected or you will not get a successful bind.
5. Hold down the button on the X4R-SB while plugging the battery into the XT-60
connector on the QQ190™. The red LED on the receiver should blink, indicating a
successful bind.
6. Unplug the battery from the XT-60 connector on the QQ190, and take the radio
out of bind mode.
7. Now plug the battery back into the QQ190™ and check to see that the green light
is glowing on the receiver. If it is, you may now unplug the battery and nish the
installation of the receiver.
8. The X4R-SB tucks in tightly under the camera. We recommend to install it with the
antennas coming out of the front of the QQ190™ and the servo plug sticking out of
the back next to the FPV antenna.
FrSky Taranis Controller Setup
If you are using a Taranis radio, You can use a pre-congured model available at
quadquestions.com/. This model should also be available for download in the “my-
account” section of quadquestions.com
To Next Page
Loading...
Need help?
General