My video is showing up on my friend’s video channel
• Verify that you are on the correct video channel
• Turn down video transmission power- when ying with more people, you
should turn down your power level.
I cannot access the OSD Menu
•
Verify that your radio trims are center
•
Verify that your radio and receiver are bound
•
Try completing an RC calibration reset.
GPS does not lock (if equipped)
• Try to move the GPS module as far away from switching power regulators, UHF
transmitters, pilot cameras and video transmitters. Leave the GPS to initialize for
30 seconds before moving the model.
Firmware update failed/ OSD not showing
Disconnect any power supply and USB cable. Press and hold the enter button and
plug-in the USB cable. This will boot the TBS CORE PNP PRO in a emergency mode. You
can now upload a working rmware to the device by the TBS Agent software.
Additional Help Resources
For more information or general help, please visit quadquestions.com and submit a
questions on our Q&A Forum. We are happy to help you there and your question will
also help other QQ190™ owners.
The QQ190™ has been setup from the factory ready to y and fully tuned. After completing
the RC calibration you should be set to arm by moving the left stick on your transmitter down
and to the right.. We recommend that you test this function before installing your props.
To Next Page
Loading...
Need help?
General