Reset Procedure
VTX/OSD Reset
If the QQ190™ starts to y in a strange manor, or if you need to reset because you
cannot nd the video channel, rst remove your props, Then make sure your radio
trims are center, then hold the reset button on the side of the power cube stack for 10
seconds. This will reset the drone to the stock output of 5865- Band A channel 1. You
will have to re- run the RC calibration procedure upon a reset.
Betaflight Settings reset
To reset Betaight settings, click reset settings from the setup screen in Betaight.
This should restore settings to default- To completely restore settings, follow the
guide to ashing new tunes and load the QQ190™ Default tune available at
tunes.QQ190racingdrone.com.
To Next Page
Loading...
Need help?
General