New or Changed Setup
Betaight will by default expect an SBUS output since this is the most commonly used
protocol nowadays among FPV racers. If you are using any other receiver such as
Spektrum satellites, or PPM-compatible receivers, press the ENTER/RESET button on
the side of the QQ190™ (gure 1) to cycle through the available options.
A restart of the ight controller is required each time you cycle through the available
options, so you must give each cycle some time to reboot. Once you have selected
your correct protocol, center all of your R/C sticks, and the R/C Calibration wizard will
launch.
** If the QQ190™ just beeps when arming and doesn't arm**
If the QQ190™ is powered on and congured in Betaight before the OSD calibration has
been completed, the QQ190™ will not arm. This is because the on screen display is set to
mandatory calibration and this menu must be exited before the QQ190™ can be armed and
own. In this case, follow the existing setup instructions below.
Existing setup (if you have already configured Betaflight)
ADVANCED
For advanced users that know their Betaight settings and who want to setup the
QQ190™ manually, select “READ CLEANFLIGHT RC DATA” in the OSD menu. This will
allow the QQ190™ to read the settings from your Betaight setup.
It is available in the R/C menu under “Flight Controller” → “Calibration” → “RC
Calibration →”Read Cleanight RC Data ”.
The read Cleanight RC data will have to be run if you choose to SKIP a mandatory
calibration procedure. After following these steps you will be able to control the OSD
and arm/disarm with your roll and pitch stick.
To Next Page
Loading...
Need help?
General