RC Calibration
RC calibration is completed via the OSD that is displayed onto the video output. It is
controllable with the transmitter sticks after a receiver has been installed and bound.
You can nd more about the Core Pro OSD features here:
http://www.team-blacksheep.com/tbs-core-pro-manual.pdf
It is recommended that you read this manual in addition to this QQ190™ manual for a
complete overview of the hardware that is installed on the QQ190™ Racing Drone.
R/C Calibration is required to teach the CORE PRO OSD and the Colibri ight controller
inside the QQ190™ which stick performs which action on your remote control. R/C
Calibration comes up either automatically if you are running the QQ190™ RTF for the
rst time, or, it is available in the R/C menu under “Flight Controller” → “Calibration” →
“RC Calibration”. You can also access the RC Calibration menu by holding the reset/
enter button on the side of the electronics stack. (gure 1) For more information see
appendix A of this manual.
Make sure the props are removed before starting the calibration.Entering the
calibration prompts.
Centering your sticks will start the
countdown. If you are not using the
currently-active RX provider (in this case
SBUS), push the Enter/reset button (gure
1) to cycle through the available options.
Follow the instructions on the screen and
move your sticks accordingly. If the direction
does not match, it needs to be adjusted in
your R/C radio conguration. Betaight can
not interpret reversed channels.
To Next Page
Loading...