Installing the Antenna
Install the provided SMA antenna by inserting it through the antenna hole on the top
plate of the QQ190™. Connect it to the SMA female adapter and hand tighten.
Failure to install the FPV antenna before powering on could damage the video
transmitter.
Installing the battery
The QQ190™ is equipped to carry 1300-1600 mAh 4S batteries. To install the battery,
install the battery strap provided through the holes on the main plate of the QQ190™
and thread it through the provided skid plate. We recommend that you route the
battery so that it's power lead comes out of the front of the drone. This will allow you
to wrap the power cable around the battery and out of the way of the props when
ying. Tuck the XT-60 connection between the battery and the strap for best results. !
To Next Page
Loading...
Need help?
General