Quantum FIREBALL PLUS AS 10.2 User Manual

ATA Bus Interface and ATA Commands
6-86 Quantum Fireball Plus AS 10.2/20.5/30.0/40.0/60.0 GB AT
6.8
6.86.8
6.8 ERROR REPORTING
ERROR REPORTINGERROR REPORTING
ERROR REPORTING
At the start of a command’s execution, the Quantum Fireball Plus AS 10.2/20.5/
30.0/40.0/60.0 GB AT hard disk drives check the Command Register for any
conditions that would lead to an abort command error. The drive then attempts
execution of the command. Any new error causes execution of the command to
terminate at the point at which it occurred. Table 6-34 lists the valid errors for each
command.
Table 6-34
Table 6-34 Table 6-34
Table 6-34
Command Errors
Note:
Note:Note:
Note: V = Valid errors for each command
ABRT=Abort command error
AMNF=Data address mark not found error
BBK =Bad block detected
CORR=Corrected data error
COMMAND
COMMANDCOMMAND
COMMAND
ERROR REGISTER
ERROR REGISTERERROR REGISTER
ERROR REGISTER STATUS REGISTER
STATUS REGISTERSTATUS REGISTER
STATUS REGISTER
BBK
BBKBBK
BBK UNC
UNCUNC
UNC IDNF
IDNFIDNF
IDNF ABRT
ABRTABRT
ABRT TKO
TKOTKO
TKO AMNF
AMNFAMNF
AMNF DRDY
DRDYDRDY
DRDY DF
DFDF
DF DSC
DSCDSC
DSC CORR
CORRCORR
CORR ERR
ERRERR
ERR
Check Power
Check Power Check Power
Check Power
Mode
ModeMode
Mode
VVVVV
Execute Drive Diag. V
Flush Cache V V V V
Format Track V V V V V V
Identify Drive V V V V V
Initialize Parameters V V V
Invalid Cmnd. Codes V V V V V
Read Buffer V V V V V
Read Configuration V V V V V V V V V V
Read Defect List V V V V V V V V V V
Read DMA V V V V V V V V V V
Read Multiple V V V V V V V V V V
Read Sectors V V V V V V V V V V
Read Verify Sectors V V V V V V V V V V
Recalibrate V V V V V V
Seek V V V V V V
Set Configuration V V V V V V V
Set Features V V V V V
Set Multiple Mode V V V V V
Write Buffer V V V V V
Write DMA V V V V V V V
Write Multiple V V V V V V V
Write Sectors V V V V V V V
Set Host Protected
ARCA Commands

Quantum FIREBALL PLUS AS 10.2 Specifications

General

Brand	Quantum
Model	FIREBALL PLUS AS 10.2
Category	Storage
Language	English