Quantum FIREBALL PLUS AS 10.2

Index
I-2 Quantum Fireball Plus AS 10.2/20.5/30.0/40.0/60.0 GB AT
ECC error handling 5-14
EEC (enable early correction) 6-79
ENDEC 5-7
error bit 6-27
error detection, correction 5-13
error rates 5-13
error recovery parameters 6-78
error register 6-24
error reporting 6-86
F
faceplate 3-1
firmware features 5-10
flex circuit. 5-4
floppy drive 3-13
Formatted Capacity 4-1
H
hardware options 3-4
headstack assembly 5-4
host software reset 6-23
Humidity 4-8
I
IDE 2-7, 3-8
IDE interface controller 5-8
IDE-bus interface 6-1
IDE-bus interface connector 3-12
identify drive parameters 6-65
Idle 4-6
input power connections 3-12
interface, IDE-bus 6-1
J
jumper configurations 3-5
jumper locations 3-4
jumper options 3-5
L
landing zone 5-4
logical cylinders 3-17
logical heads 3-17
logical sectors/track 3-17
low 4-3
low-level format 4-3
M
maximum screw torque 3-10
mechanical dimensions 3-1
microcontroller 5-7
motherboard 3-13
Motor Controller 5-8
mounting 3-9
mounting dimensions 3-9
mounting holes 3-9
mounting screw clearance 3-10
mounting screws 3-10
MS-DOS 3-18
MTBF 4-10
N
noise 4-5
Nominal conditions 4-4
Non-repeatable errors 5-15
number of retries 6-79
P
packing assembly 3-2
packing materials 3-2
PE (prefetch enable) 6-78
Peak Detect 5-9
PM 4-10
power and AT bus connector 3-11
power and bus interface cables 3-14
power connector 3-11
Power Requirements 4-6
Power Sequencing 4-5
pre-amplifier 5-10
pre-compensator 5-9
precompensator circuit 5-7
printed circuit board 3-4
programmed I/O 6-21
Pulse Detector 5-9
PWM 5-7