Quatech SDS User’s Manual Introduction
Getting started
Unpacking your SDS
Follow these steps to unpack your SDS.
Step Procedure Description
Step 1 Remove the SDS from the box.
Step 2 Remove all packing material from the SDS. Save the packaging in case you ever need
to store the unit or return it to Quatech
for service.
Step 3 Check the contents of the package to make
sure you have received everything listed
below:
¾ SDS
¾ Power cable
¾ Power source
¾ Loopback connector(s)
¾ CD-ROM containing the SDS device
drivers and configuration software
¾ Quick Start Guide
The complete SDS package ships in a
single box.
Step 4 Check the SDS and accessories for shipping
damage.
Pay particular attention to the SDS’ case
and port connectors. If anything is
missing or damaged, contact your
Quatech sales representative.
July 2005 940-0183-153 Page 7
To Next Page
Loading...
General