Import: Here you can import the configuration files from the peripheral device to current
device. You need to select a folder first. You will seea dialogue box asking you to select a
folder if you are selecting a file. System pops up a dialogue box if there is no configuration
file under current folder. After successfully import, system needs to reboot to activate new
setup.
Format: Click Format button, system pops up a dialogue box for you to confirm current
operation. System begins format process after you click the OK button.
Note:
System can not open config backup interface again if there is backup operation in the
process.
System refreshes device when you go to the config backup every time and set current
directory as the root directory of the peripheral device.
If you go to the configuration backup interface first and then insert the peripheral device,
please click Refresh button to see the newly added device.
Figure 5-65
To Next Page
Loading...
Need help?
General
