4.5.2.2 Activation Snapshot
Please follow the steps listed below to enable the activation snapshot function. After you
enabled this function, system can snapshot when the corresponding alarm occurred.
In Encode interface, click snapshot button to input snapshot mode, size, quality and
frequency. See the interface on the left of Figure 4-20-A.
In Detect interface please enable snapshot function for specified channels (interface in
the middle of Figure 4-20-D). Please enable snapshot function for specified channels.
Please refer to the following figure for detailed information. See Figure 4-20-D.
Figure 4-20-D
4.5.2.3 Priority
Please note the activation snapshot has the higher priority than schedule snapshot. If you
have enabled these two types at the same time, system can activate the activation snapshot
when alarm occurs, and otherwise system just operates the schedule snapshot.
4.5.3 Image FTP
In Network interface, you can set FTP server information. Please enable FTP function and
then click save button. See Figure 4-21.
Please boot up corresponding FTP server.
To Next Page
Loading...
Need help?
General
