5.5.1 HDD Management
Here is for you to view and implement hard disk management. See Figure 5-48. You will see the
current HDD type, status, capacity and record time installed. When HDD is working properly,
system is shown as O. When HDD error occurred, system is shown as X.
Alarm set: Click alarm set button, the interface is shown as below. See Figure 5-. (This
interface is just like the abnormity setup). Please refer to chapter 5.5.2 for detailed
information.
HDD operation: You can select HDD mode from the dropdown list such as read-only or
you can erase all data in the HDD. Please note system needs to reboot to get all the
modification activated.
Figure 5-48
Please highlight icon to select the corresponding function.