RadioLink Electronic Limited
www.radiolink.com
3.2 Throttle and Steering Calibration
The function is used to correct the steering wheel, throttle trigger and VR knob of the transmitter. When there
is mechanically offset of the travel amount, the function can also be used.
Video tutorial：https://www.youtube.com/watch?v=UsbM9p7jx5s
1. Power the transmitter with the battery. Press and hold Exit and Dec(-) buttons at the same time and turn on
the transmitter.
2. After powering it on, the transmitter will enter the following calibration interface.
3. Push the throttle trigger all the way forward and then push it all the way back. The value of the calibration
interface will change at the same time.
To Next Page
Loading...
