Radionics Security System User Manual

14
Turning On Part of the System (Part On)
I have this feature.
I do not have this feature.
Part On turns on only a part of your system, leaving the rest of the
system turned off. Refer to the Point Identification section of your
keypad’s reference card to identify Part points. Once you’ve pressed
the 0 key, exit delay time starts to count down. You should leave before
exit delay time expires. Leaving after exit delay expires causes an
alarm event. Use Part On when you want part of your system turned
on.
1. Make sure that Part points are normal. In this example, points
5, 6, 7, and 8 are Part points. Press the 0 key. The display shows:
2. If all Part points are normal, exit delay time begins. If your
system has faulted points, you should return them to normal, or refer
to Bypassing Points.
3. During exit delay, you may stop the system from turning on by
pressing CLEAR.
4. When exit delay time expires, the keypad beeps three times
and then the system turns on.
5. To turn the system off, enter your personal passcode.
71-07374-000-B Users Guide.p65 08/21/2001, 1:05 PM14

Radionics Security System Specifications

General

Brand	Radionics
Model	Security System
Category	Security System
Language	English