17
Viewing Alarm Memory
After an alarm has been silenced and cleared from the display, you
may still review the points that had been in alarm.
1. Ensure that the system is turned off (On light is off). If there has
been an alarm, and the system dialed your alarm company, the OK
light will be flashing. If you cancelled the alarm by turning the system
off before it dialed your alarm company, the OK light will not be
flashing.
2. Press the 4 key. The following display shows that there are
alarms in memory:
3. Press and hold the 6 key to view those points which were in
alarm. This display shows that there was an alarm on point 4:
Flash = Alarm On = Cancelled Alarm
4. Reset the system or turn the system on again to clear alarm
memory.
71-07374-000-B Users Guide.p65 08/21/2001, 1:05 PM17
To Next Page
Loading...
