16
Turning the System On, with Points Open (Bypassing Points)
I have this feature.
I do not have this feature.
Use this feature to selectively exclude points you do not wish to
turn on with the rest of the system. For example, you may wish to
bypass the patio door while turning on the remainder of the system.
1. Press the 9 or 0 key to turn the system All or Part On.
2. If a point is faulted, the error tone sounds and the point light for
the faulted point winks. In this example, point 5 is faulted.
3. Press the key for the point you want to bypass. In this example,
you would press the 5 key. The point light goes off. The exit tone
starts when all faulted points are bypassed.
4. If you bypass a point in error, press CLEAR and start over at
step 1.
5. Exit now or turn the system on with no delay by pressing 9 or 0
a second time.
6. When exit delay time expires, the keypad beeps three times and
the system turns on. The All or Part light and the OK light wink to
indicate that the system is on with points bypassed.
7. Turning the system off clears all bypassed points.
71-07374-000-B Users Guide.p65 08/21/2001, 1:05 PM16
To Next Page
Loading...
Need help?
General
